Development of anti-infrared camouflage cloth-2
Apr 07, 2024
1.1 Adjustment of color light
For polyester and cotton varieties, when the shades are close to each other, the dosage of disperse dyes is generally adjusted to match the color of the customer's sample. Disperse dyes have basically no effect on the reflectance curve; for pure cotton varieties, the only way to achieve the desired color is by adjusting Shihlin dye. When adjusting the color light, care should be taken at this time to avoid affecting the infrared reflectance curve.
1.2 Control of color fastness
Anti-infrared camouflage has relatively high requirements on soaping fastness. Generally, the ISO standard must reach level 4-5. First of all, Shilin and disperse dyes with better fastness should be selected; secondly, soaping should be strengthened. In addition to adding soap powder and soda ash normally, the soaping temperature must reach above 95℃, and soaping needs to be done twice if necessary.
1.3 Weighing materials should be accurate
When preparing color paste and weighing materials, do not weigh incorrectly or under-weight, especially black paint should be weighed with a balance. Before getting on the truck, you should take a finger sample to ensure that the material is weighed correctly, and the viscosity of the color paste must be measured to meet the requirements before you can get on the truck.
1.4 Control of printer operation
Anti-infrared camouflage, strict requirements on various indicators. The operating procedure is more cautious. Generally, a 10m large sample is placed first and sent for testing. After passing the test, a 500m medium sample is placed and sent for testing again. Mass production can only be carried out after the infrared indicators, various fastnesses, and printing effects are fully confirmed. During normal production, factors such as the selection of the magnetic rod, the size of the magnetic force, the vehicle speed, the viscosity of the color paste, the selection of the mesh, and the level of the liquid level in the mesh must be completely consistent with the parameters when placing the sample.
Epilogue
1. Try to use environmentally friendly finishing agents to ensure the ecological safety of functional finishing products, and strive to make the production process clean and environmentally friendly.
2. On the premise of meeting customer requirements, domestic additives will be the first choice to help reduce costs.
3. After functional finishing of fabrics, there is a common problem of color change, which should be considered in advance when imitating color patterns.
4. Most functional finishing processes are simple and only require ordinary rolling-baking-baking processes, and the production feasibility is good.
5. The value of ordinary printed and dyed fabrics has doubled after functional finishing, which increases the added value of the product and opens up a new way for high-end processing of mid- to low-end products.







